add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Almera (from 1995 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Almera
Home
 
Nissan
Almera
General Information
General requirements for car repair
Operation and maintenance of car
Passport details of the car
Points lifting and towing vehicle
Kontrolnoizmeritelnye devices
Signal and warning lights, audible alarm
Controls
Door locks
Castle trunk
Cover and plug the fuel tank
The front seats
Folding rear seats
Headrests
Sunroof
Seat belts
Courtesy light and reading lights
Lighting trunk or luggage
Running a new car
Engine start
Using automatic transmission
Quickly switch from position ?�D?� to a lower gear
Switch overdrive
The movement of a vehicle with an automatic transmission
Check the engine oil level
Replacing the engine oil
Changing the oil filter
Checking the coolant level
Checking the oil in a mechanical transmission
Checking the oil level in the crankcase of an automatic transmission
Check the fluid level in the power steering reservoir
Check the fluid level in the fluid reservoir Clutch and brake
Check the fluid level in the washer fluid reservoir and a cleaner of headlights
Replacing bulbs
Wheels and tires
Petrol engines
Diesel engines
Transmission
Chassis
A steering
The brake system
Electrical
Body
Applications
Scheme of electrical equipment
 


Hit Counter by Digits


print page printable version

The movement of a vehicle with an automatic transmission



Procedure while driving should be as follows:
- Set the selector lever in position ?�N?�;
- Depress the brake pedal;
- Start up the engine starter, without releasing the brake pedal;
- Without increasing the speed of the engine is idling, move the gear lever into one of the driving position (?�D?�, ?�R?�, ?�2?� or ?�1?�);
- Release the brake pedal and start driving.

WARNINGS
1. Do not increase the engine speed to idle. This can lead to a sudden onset of motion of the machine, if the selector lever is in position ?�D?�, ?�R?�, ?�2" or "1", or damage to the engine if it is in position ?�N?� or "P".
2. On models with selector lever lock button, to move from the position "P" on any transfer movement, press the brake pedal. The locking mechanism is activated only when the ignition key, or switch devices and the starter is in the ?�ON?�.
3. Be especially careful when changing gear (both front and reverse) as long as the engine is warm, as the idling speed at cold engine is higher than that of the heated.
4. When parking, even for a short time, put the selector lever in position ?�N?� and set the parking brake.
When you stop the car on the lift to press the brake pedal, switching pre-selector in position ?�N?�, to keep the car on the spot and prevent transmission from overheating.




« previos page
Switch overdrive
next page »
Check the engine oil level

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.