 printable version
Replacing the rear wheel sensor rotor
Lift the rear of the vehicle. Remove the wheel from the right side. Remove the rear wheel hub (see. Above). Hold the hub in a vise and use puller as the rotor when removing the front wheel, remove the rotor from the hub.
| Fig. 7.21. Rotor speed sensor rear wheel: a = 4.5-5.5 mm
|
Thoroughly clean the seat sensor rotor on the hub. Fit the new rotor by means of the press, the mandrel and the appropriate equipment. At the same time, make sure that the rotor was recessed at 4.5-5.5 mm from the end of the hub (Fig. 7.21).
| Fig. 7.22. Backlash check speed sensor of the rear wheel
|
The gap between the rotor and the sensor (Fig. 7.22) is not regulated, only monitored. The gap should be 0,1- 1.1 mm. Follow the remaining operations in the reverse order of removal.
| 
