REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Almera (from 1995 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Almera
		General Information
		General requirements for car repair
		Operation and maintenance of car
		Petrol engines
		Diesel engines
		Transmission
		Chassis
			Front suspension
			Rear suspension
				Removing and installing rear strut
				Disassembly and assembly of the rear strut
				Removing and installing rear axle
				Replacing the rear wheel hub
		A steering
		The brake system
		Electrical
		Body
		Applications
		Scheme of electrical equipment

printable version

Disassembly and assembly of the rear strut

Fig. 5.15. Position the bottom of the cup springs and the top support: A - arrow pointing to the front of the vehicle; B - Left Front;

B - Right Front; 1 - position of the lower end of the spring; 2 - an axis perpendicular to the axis of the hole bottom sleeves shock absorber

Fig. 5.16. The position of the spring suspension:

1 - lower bearing cup spring; 2 - the upper spring seat is removable; 3 - the upper spring coil

Dismantling the rear strut is similar to the dismantling of the A-pillar. Replacement of shock absorbers and springs are also recommended to perform in pairs, ie, the left and right sides. When installing the springs and support plates follow the figure. 5.15 and 5.16. Finally tighten the screw connections after the lowering of the wheels on the ground.

« previos page
Removing and installing rear strut

next page »
Removing and installing rear axle