 printable version
Replacing the bulbs in the headlights and dipped beam
Headlamp washers require careful handling. Do not touch the bulb hands. Clean the lamp with a cloth, lint-free cloth. If you accidentally touch hands, clean the lamp bulb with a cloth moistened with alcohol. Lamps used by car are listed in Table. 1.10.
| Fig. 1.57. Replacing the headlight bulb (A) and front side light bulb (B): 1 - a protective cover; 2 - rubber casing; 3 - spring latch; 4 - pin lamp; 5 - side light bulb holder
|
Open the engine cover. Remove the "minus" terminal to the battery. Disconnect from a cap lamp electrical connector. Turn counterclockwise the cover and remove it. Remove the rubber protection cover. Press and rotate the spring latch. Carefully remove the lamp, took her by the electrical contacts (Fig. 1.57, A) The installation of the lamp spend in the reverse order of removal. Pay attention to the installation of a dense rubber casing.
Table 1.10 Lamps used car Fitting Position | Power, W | Number | Middle / high beam headlights (H4 type) | 55/60 | 2 | Front side light | 5 | 2 | Fog lamps (type NC) | 55 | 2 | Side turn signal | 5 | 2 | The front turn signal | 21 | 2 | Side lights in the rear light / brake light | 5/21 | 2 | Rear turn signal | 21 | 2 | Reversing light | 21 | 2 | Rear fog light | 21 | 2 | License Plate Light | 5 | 2 | Lighting luggage compartment / trunk | 5/3 | 2 | Reading lights | 10 | 1 | Courtesy light | 10 | 1 | Additional stop light: |
|
| sedan | 5 | 6 | hatchback | 21 | 1 |
| 
