printable version

Seat belts

general information

Information about emergency seatbelt tensioners, refer to Section System of additional safety (SRS).

All individuals in the car while driving people should wear seat belts, which is reminiscent of the buzzer and the special K / A in the instrument cluster (see. Some car equipment, arrangement of devices and controls). K / L lights when the safety belt of the driver or front passenger is not wearing a seat with the ignition on. The buzzer is activated when unbelted driver or passenger at a speed of 25 km / h.

Seat belts front seats and side rear seats have a bias-waist design. The central rear seat lap belt is installed.

Do not use a seat belt fastening for more than one person.

Explain section of the belt should be positioned at the level of the hips, to cover the hip joint sitting, as the most robust element of the human skeleton. The shoulder section of the belt is not allowed to pass under the arm or neck superimposed on sitting. Make sure the belt is not twisted.

Remember that the maximum efficiency of the belt is achieved in the vertical position of the seat. Excessive backrest increases the likelihood of slipping under the belt sitting on impact.

Seatbelts bias-belt design have three anchor points, one of which is equipped with inertial reengaging with automatic locking at jerks. Belts of this type does not need to be adjusted in length. Waist belt design has two anchor points for safety belt must be so dead to keep fastened.

Terms of use seat belts

Slowly pull the strap from the return device perekin'te his shoulder (only trehankernye belts) and snap the clip belt buckle in the lock, then pull the shoulder strap sections (only trehankernye belts) up Check the fixing brackets in the castle. Make sure the belt webbing is not twisted - twisted strap itself is dangerous.

Maximum lower section of the waist belt, placing it as low as possible on the hips. Pull the shoulder belt section trehankernogo up the slack and try to achieve a snug fit to the body belt - if necessary, tighten the belt properly. The strap must pass through the thorax sitting diagonally so that the impact load is mainly in the most secure part of the upper torso. The upper front seat belt can be adjusted in height. To do this, press the release button and move the upper loop of a belt to the desired position. After adjustment, pull the strap to make sure that the loop is securely locked.

If desired, to better position the belt can be adjusted and the height of the seat cushion.

The driver of the vehicle, strapped his belt, I shall ensure that all the passengers were properly secured.

To unfasten the belt, press the red button on the lock body. When you wrap the belt return drum unit should hold his buckle. After leaving the car, make sure that the belt is not squeezed door.

Do not attach the straps to the seat belts, no pads and other items. No extra devices or repositioning the mounting shoulder section can reduce the effectiveness of the seat belt and increase the chance of injury in an accident.

Recommendations for pregnant women

Ensuring the safety of the pregnant woman is the best way to preserve the fruit in case of accident, therefore, when driving a car (as driver or passenger), a pregnant woman must compulsorily wear a seat belt, paying particular attention to the correct placement of its sections relative to its body.

When using the seat belt diagonally design should be remembered that the belt section of the belt should be positioned as low as possible on the hips, and in any case is not on the stomach.

Pregnant women should also take a seat in the upright position. At the same time the front seat should be as far as possible to move away from the instrument panel, which will in the event of an accident or operation of front airbags reduce the risk of injury and injury not only pregnant, but also to the fetus.

Every visit to the attending physician, consultation, whether it is desirable for you to drive.