REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Micra
		Introduction
		Controls and operation receptions
		Options and car routine maintenance
		Engine
		The engine cooling system, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change and clutch
		Automatic Transmission
		Drive shafts, steering knuckles and Hub assembly
			general information
			Removing and installing the steering knuckle
			Replacing anther drive shafts
			Removing and installing drive shafts
			Disassembly and assembly of the drive shaft
			Removing and installing the hub of the rear wheel assembly
		Brakes
		Suspension and steering
		Body
		Onboard electric
		Diagrams

Removing and installing the hub of the rear wheel assembly

Hub assembly


1 - Back plate 2 - Spindle 3 - The rotor wheel ABS sensor 4 - Wheel bearing	5 - Retaining Ring 6 - Brake Drum 7 - Cap nut Hub

PERFORMANCE ORDER

Poddomkratte car and establish it on props. Remove a corresponding wheel and cock a lay brake.
Remove the cap of the hub nut.
Give the hub nut and remove the spindle brake drum.
Remove the rotor wheel sensor.
Give the self-locking nut and separate from the brake parking brake cable (see chap. Brake System).
Disconnect from the wheel cylinder brake pipe.

Do not press on the brake pedal when removing the brake drum and the tube disconnected.

Remove the bolts and separate its spindle assembly from the back plate of the suspension arm.
Installation is in the reverse order, if necessary, refer to Chapter Brake System. After installation, bleed the brake system (see chap. Adjustment and car routine maintenance).

next page »
Brakes