printable version

Removing and installing rear brake assembly

Withdrawal

Assemble the back brake mechanism

1 - Drum 2/3 - Lower / upper coupling spring 4 - expander strap 5 - Lock 6 - Terminal 7 - The wheel cylinder 8 - bleeder valve	9 - Protective cap 10 - Piston 11 - Supporting Cup 12 - Spring 13 - Brake shield 14 - Guide Blocks

PERFORMANCE ORDER

Poddomkratte the car and remove a corresponding wheel. When is released the parking brake, remove the brake drum (see. Section Removal and installation of the hub assembly of the rear wheel). Simultaneously pressing and turning locks, pull out the pads and remove the pad assembly. Without damaging the protective caps of the wheel cylinder. Disconnect the parking brake cable. If necessary, remove the tie from the pad spring and spacer bar. To remove the wheel cylinder disconnect the brake tube and remove its mounting bolts.

Setting

PERFORMANCE ORDER

If removed, install the wheel cylinder. Nissan KRF0000005 Grease sliding surfaces in the brake shoes and in the diagram of the brake shield. Shorten Expanding the bar, turning her tip. Expanding plank on the left / right side of the vehicle is correspondingly left / right-handed thread. Connect the blocks Expanding the bar and return spring. Connect the parking brake cable. Install the pad assembly, being careful not to damage the protective caps of the wheel cylinder, and make sure that components are installed correctly. Install the brake drum (see. Section Removal and installation of the hub assembly of the rear wheel). Adjust the parking brake. If you shoot the wheel cylinder, bleed the brake system (see. Section Replacing brake fluid and bleeding the brake system).