 printable version
Front suspension
Removing and installing, disassembling and assembling the strut Refitting The components of the installation and assembly of strut front suspension shown in the illustration front suspension. | - Remove a corresponding wheel.
- Remove the cowl of the windshield.
- Remove the rack from the wiring of the wheel sensor ABS (see chap. Brake System) and lock plate brake hose.
- Remove the stabilizer link suspension.
- Give nuts and bolts to the steering knuckle front suspension.
- Remove the upper strut mounting bolts and remove it from the vehicle.
 | - Installation is in the reverse order. The label on top of the rack should be facing forward.
|
|
|
Disassembly and assembly |  | - Fasten the removed rack suspension in a vise, and set her adaptation for spring compression.
|
- Slightly give the lock nut, compress a spring and only then finally give the locknut.
 | Do not give the locknut completely, until the spring would not be recorded in a compressed state. |
- Remove the rack from the seat springs, bearings, springs and bellow.
- Check the condition of the shock absorber and removing components, if necessary, replace them.
- If you want to replace the spring, carefully release the compression tool and install it on the new spring.
 | - Install the spring on the counter so that the lower turn rested on a corresponding projection.
|
| | - Install Kit, bearing and upper spring seat. Make sure all installation upper spring seat.
|
- Hand tighten the lock nut, remove the tool to remove the springs and tighten the lock nut with a force of 60 ÷ 75 N ??? m.
|
|
|
