 printable version
Removal, installation and adjustment of lighting
 | The following describes only the removal. Installation is in the reverse order. |
Block lights
| - Remove the locker corresponding wheel arch trim and the front bumper (see chap. Body).
 | - Disconnect the wiring block headlights and turn its mounting bolts.
|
- Lift the top bracket, pull the headlight forward.
|
|
Fog lights | - Remove the locker and front bumper (see chap. Body).
 | - Remove the bolts and remove the fog lamp.
|
 | - After the headlamp should align it with the adjusting screw, as described below.
|
 | - Align the top edge of the lens fog lamp in accordance with the illustration and turn the fog lights. If necessary, close the lens unit.
|
 | - Turn the adjusting screws, set the optical axis of the headlamp in accordance with the illustration.
|
|
|
Front direction indicators | - Remove the radiator grille (see chap. Body).
 | - Unscrew and remove the pointer turns him from releasing locks.
|
|
|
Side direction indicators |  | - Pull the side direction indicator to B, at the same time pushing it in the direction A, and separated from the wing.
|
- Disconnect the electrical wiring of the side direction indicator.
|
|
License plate light | - Pry the plastic wedge and remove the lens assembly of the license plate light out of the bumper.
|
|
Stoplight top level |  | - Open the tailgate with both hands and pull the cover stoplight top-level direction A, to remove it.
|
- Press the foot locks to B, unhook the upper clips, and press the brake in a direction C, to remove it.
|
|
The rear combination lamp |  | - Open the tailgate and remove the bolts the rear combination lamp.
|
- Remove from the vehicle lights, pulling it back and disconnect the wiring.
|
|
Cabin Light |  | - Trying not to damage the finish of the ceiling, pry off the rear lamp plastic wedge and release the light from the metal clamps.
|
- Disconnect the wiring and remove the lamp.
|
|
|
