|
|
 printable version
Removing and installing moldings and seals
Roof molding Mounting roof molding 
 | Other moldings replaced similarly. |
| - Plastic wedge raise the rear edge of the roof molding, remove the lock and cut two-sided adhesive tape attachment molding.
- Remove remnants of adhesive tape with moldings and body.
- Clean the mating surfaces of the roof and moldings.
- Glue the latch side of the body and wait at least 40 minutes.
- Apply the primer (for example, Sumitomo 3M N200) for mating with the back surface of adhesive tape fastener from the body.
- Stick adhesive tape on the rear side of the retainer body-side
- Dock the front of the roof molding to seal the windscreen, press the roof molding from front to back and fasten it to the body with the help of two-sided adhesive tape and clips.
|
|
Sealing windscreen | - Remove the cowl of the windshield (see. Section Removal and installation of the fairing windshield).
 | - Disconnect from the wing covers on cutting the two-sided adhesive tape.
|
 | - Apply masking tape around the perimeter of the windscreen seal and cut lip seal.
|
- Remove the remaining seal.
 | - Apply the primer and adhesive.
|
- Align the white mark on a new windshield seal spacer with a label on the top of the windscreen.
- Push arms seal so that its lower beard caught on the glass, and then press the seal outwards.
- Remove the protective tape and install the cover of the wings and windshield cowl.
|
|
Seals glass side doors Fasteners seal glass side doors 
| - Fully lower the glass door.
- Grasp the seal and pull it up to release from clamps (starting from the rear).
- Installation is made upside provide designated.
|
|
|
|
