REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Patrol (from 1988 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Patrol
		Introduction
		Troubleshooting
		Adjustment and routine maintenance
		Engine
		System of cooling, heating and air conditioning
		The power supply system and exhaust
		Systems for reducing emissions
		Systems of an electric motor
		Transmission
		Clutch
		Brakes
		The front and rear axles, chassis and steering
		Body
			Care body
			Removing stains of different origin with vinyl upholstery and trim panels
			Care of an upholstery and rugs salon
			Repair minor damage to body panels
			Repair of considerable damages of a body
			Replacing the windscreen and of fixed glass panes
			Service of the front door
			Maintenance rear doors
			Removing and installing bonnet
			Service tailgate models of Hardtop (Hardtop) and Universal (Station Wagon)
			Service tailgate models of utilities (Van) (Utility)
			Removing and installing radiator grille
			Removing and installing center console
			Removal and installation of the front seats
			Removing and installing rear seat
			Service seatbelts
			Removal and installation of the instrument panel
		Onboard electric

printable version

Removing and installing radiator grille

The order of the procedures for removing and installing the radiator grille is the same for all car models. The following describes the procedure for models of Hardtop and the Versatile.

Withdrawal

PERFORMANCE ORDER

Lift the hood and secure it with emphasis.
Give fixing screws combination lamps to the front of the vehicle panel. Remove the lights, after disconnecting them from the wiring.

Use a screwdriver to turn a quarter turn fasteners (arrows on an accompanying illustration (utilities (Van) and Mini-truck) and (Hardtop and Touring)).

Slightly tilt the grille forward, then pull it up to remove.

On some vehicles may previously have to remove the frame skotootboynika (depending on the design).

Setting

Installation is in the reverse order.

PERFORMANCE ORDER

To remove the clamps from the front end panel squeeze them and turn a quarter turn.
Insert the tabs into the square holes in the lattice, and then turning them.
Install the grille on the bottom anchor points and push it back to the panel snaps into place in the ancestor.
On models of Hardtop and the Versatile set combination lamps, firmly tightening the screws attaching them.

« previos page
Service tailgate models of utilities (Van) (Utility)

next page »
Removing and installing center console