Removing and installing front wheel drive

To remove the front wheel drive, do the following:

- Remove the wheel covers and loosen the wheel bolts;

- Post the relevant front of the car and establish it on support;

- Remove the wheel;

- Fixing the wheel hub in a fixed position, unscrew the bolts of the shaft;

- Disconnect the drive from the gearbox;

- Unscrew the knuckle and move it to the side (Fig. 5.130);

- Pulling out the wheel hub, disconnect the drive from the knuckle.

Front Wheel Drive Installation spend to sequences, return to removal, taking into account the following:

- Thoroughly clean the splines of the drive shaft and the inside of the wheel hub grease;

- Tighten the nut wheel torque of 265 Nm and the inner flange joint bolts - 45 Nm;

- For vehicles with engine capacity of more than 2.0 liters per inner CV joint (diameter 100 mm) affix a new gasket.