 printable version
Replacing the wiper arm
Replace the wiper arm performed as follows: - Geared motor wiper switch, and then turn it off when the wiper arm will return to off (down) position;
NOTE If you want to remove both the windscreen wiper arm, they must mark, as they are not interchangeable. |
- Pry and remove the cap nut axis of the wiper arm; - Loosen the lock nut, lift the brush off the glass and remove the wiper arm with the axis (lever can be picked up and removed from the shaft using a suitable flat blade screwdriver); - Make sure that Spitz wiper arm and the axis of rotation are clean and dry; - Put a new arm on the axis of the brush in the correct position and place it on the glass; - Check the installation of a new brush. The lower edges of the wiper blades in a stationary state should be placed about 50 mm from the bottom edge of the windscreen; - Tighten the lock nut to 20 Nm; - Windshield wiper switch and make sure the wiper blades when his work is constantly returning to the "correct" position; - The cap nuts to their original location.
| 
