 printable version
Removing the battery
Location of the fuses on the battery
| 1 - Mount positive wire;
2 - an electric socket;
A - nuts |
Location conductive fastening clamp plate to the positive terminal of the battery
| Fastening clip conductive plate to the positive terminal of the battery is shown by the arrow. |
Explanation of the symbols on the battery label
1 - when servicing the battery is necessary to observe the safety instructions set out in the manual;
2 - the battery has a corrosive acid and should be careful to not acid spilled from the battery;
3 - Do not use an open flame near the battery;
4 - when working on the battery Use protective goggles;
5 - Keep the battery out of the reach of children;
6 - at the disposal of the battery hand over only to designated points;
7 - Do not throw away the battery with household waste;
8 - gases given off when charging the battery, explosive
The battery is installed in the engine compartment behind the left headlight.
A warning  When disconnecting the battery terminals in the blocks of memory controllers erased data recorded faults, so before disconnecting the battery terminals, it is desirable to address in a specialized workshop for the Memory Recall recorded in her fault. After connecting the battery terminals should be intensified and reprogram the power windows and the position of the door mirrors and seats.
Also, if the car is equipped with a radio code before disconnecting the battery terminals from the check that you have the code to reactivate the receiver. Otherwise, enter the radio operation will be possible only at special stations for Volkswagen.
Withdrawal
| PERFORMANCE ORDER | | 1. Turn off the ignition. | | 2. Open the hood. | | 3. Remove the negative terminal of the battery and move it to the side. |  | 4. Squeeze the two sides of the fuse holder cover (shown with arrows) and open it. | | 5. Loosen (1) positive wire (see. Fig. Location of the fuses on the battery). | | 6. Label the fuses and remove them from the spring contacts. Unscrew the nuts (A). | | 7. Disconnect the electrical connector (2). |  | 8. Using the thumb and the blade screwdriver, remove the fuse holder from the body of the battery (indicated by arrows). | | 9. Move up the body of the fuse holder, remove it from the battery. | | 10. Loosen and remove the conductive plate to the positive terminal of the battery (see. Fig. Location of fastening clamp conductive plate to the positive terminal of the battery). |  | 11. If you have open and remove the casing thermofilter battery (arrow). |  | 12. At the bottom of the battery, unscrew the bolt (arrow) and remove the plate securing the battery. | | 13. Move the battery to the side, with the release mount the second side of the battery and remove the battery from the engine compartment. | | 14. The battery has a sticker with warning symbols (see. Fig. Explanation of the symbols on the label of the battery). |
|
|
