REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
			Lubrication system
			Cooling system
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
			Lubrication system
			System ohlazhdeiya
			Fuel system
				Removal of the fuel from the fuel tank when filling the fuel tank more than 3/4
				Pumping of fuel from the fuel tank is less than 3/4
				Check the functioning and power
				Checking fuel pressure
				Check of residual pressure
				Performance Verification
				Electronic control of engine power (electronic throttle actuator)
				Removal and installation of the accelerator pedal assembly
				Absorber
				Check pumping fuel tank
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Removal of the fuel from the fuel tank when filling the fuel tank more than 3/4

ATTENTION

Fix the earth wire device for pumping fuel at the site uncovered the body.

Fig. 2.203. Stick the tape

At a distance of A = 990 mm from the end of the hose pump down glue on the hose length of tape (Fig. 2.203).

Remove the filler cap of the fuel tank.

Opustiteotkachivayuschy hose to the fuel tank so that the applied pre-tape mark is at the level of the filler neck.

NOTE

Handle 1 is not further used.

At the lower end of the filler neck in the fuel tank is a valve. When lowering or removing the pump down the hose be careful not to damage it. Therefore, lower the hose should be applied only to advance the mark.

Pump out as much fuel from the tank through the filler neck.

Carefully remove the bilge hose.

NOTE

If the fuel is no longer pumped, the fuel tank is drained so that the flange of the sensor can be safely opened. With the remnants of the fuel tank can be removed.

« previos page
Fuel system

next page »
Pumping of fuel from the fuel tank is less than 3/4