 printable version
Check and fill Transmission oil
NOTE Checking the transmission oil presently known methods is impossible. It was changed the slope of the power unit. |
| Fig. 3.55. The lower edge of the filling hole
|
Therefore, the lower edge of the filling hole 1 is below the new oil level 2 (Fig. 3.55). The oil level in the gearbox can be checked only with the full release of the transmission oil and a new filling.
Preparation Remove the air filter assembly. Remove soundproofing. Clean the gearbox.
ATTENTION For the release of the transmission oil spigot for forks in the gearbox must be removed. In order to position the forks are not changed, eg., Due to unintentional pressing of the shift actuator, it is necessary to set the shift shaft. |
Fixing shift shaft
| Fig. 3.49. Small and safety gear rope on and gear selection
|
Click on the selector shaft down (the direction of the arrow 1) (Fig. 3.49). When pressed on the shift shaft, turn the corner in the direction of the arrow A 2-up, and at the same time gently push it in until it clicks into switching shaft.
Release transmission oil To collect the gear oil, use a clean receptacle with a capacity of 3.0 liters with scale. Selector shaft must be fixed.
1 Remove the drain plug and then remove the pin 2 and release the gear oil (Fig. 3.56). Establish a pin 2 with a new seal. After that, return the area A to the original position (the arrow) to shift shaft again I had a free lift
Fill transmission oil Top up gear oil in the tank to 1.9 liters.
Connect tube (length 600 mm, outer diameter 10 mm) with a standard funnel. Insert the hose into the opening of the switch mounting reversing lamps. (2nd mechanic) and fill with gear oil. Again, set the reversing light. Check the operation of the drive gear. Install the air filter housing assembly. Install soundproofing.
| 
