Overview

Differences clutches

Bleeding the clutch assembly

Removing and installing the support bracket

Removing and installing servopruzhiny

Removing and installing clutch pedal

Removing and installing master cylinder

Hydraulic clutch

Removal and installation of the working cylinder

Installing the drive gear

Removing and installing clutch production Sachs

Removal and installation of the production of LuK clutch

Check clutch

Repair of the drive gear

Removal and installation of the cuff with a button switch and noise insulation

Removing and installing control cables - parts and components

Removal and installation of the drive gear

Adjusting drive the drive gear

Passat for cars with manual gearbox set single-plate dry clutch with plates, not containing asbestos, and dual-mass flywheel. Management is carried out by means of hydraulic drive clutch. Cars with automatic gearbox equipped with a hydraulic multi-plate clutch.

During operation, maintenance-free coupling: when the pads worn parts themselves aligned. Replace clutch disc should be done after 100 000 km, but this depends on the load conditions of the vehicle.

Depending on the type of engine and gearbox clutch design may vary somewhat.