 printable version
Rear view mirrors
| Fig. 1.38. The control circuit rear-view mirrors
|
Rear-view mirrors must be installed before the trip so that at any time you could see the road conditions behind the car.
Installing exterior mirrors Installing exterior mirrors with electric drive. Installation of the exterior mirrors is carried out by turning the button. L - left mirror. A - heated exterior mirrors. R - right mirror. Upon cancellation, you can install the electric exterior mirrors manually by pressing on the rim of the mirror. B - both mirrors are folded. In this position, the two outer mirrors button folded. When you turn the key in any other position both mirrors back into the working position.
ATTENTION If the position of the exterior mirror due to the impact of power has changed (for example, at the touch of another car when maneuvering) should both mirrors folded (bring to the body) by means of electric drive. In no event it is impossible to restore the position of the mirror hand as ETS adversely affect the operation of mechanisms of the installation of the mirror. |
Simultaneous installation of exterior mirrors First, you must install both a mirror to its original position. To do this, a mirror separately as described above. You can then at the same time we establish a mirror, both during the installation of the left mirror.
Directions for use of convex and aspherical exterior mirrors
Convex mirrors increase the field of view, while the subjects are presented in a reduced form. For this reason, these mirrors only very conditionally suited to estimate the distance to the next car moving (Fig. 1.39).
Aspherical mirrors have mirror surfaces of different curvature. These wide-angle mirrors increase the field of view, even more than the convex mirror. They also only very limited suitable to estimate the distance to the next car moving.
Folding exterior mirrors Exterior mirrors the car can be folded. To do this, press the mirror housing to the car body. Before going through the automatic car wash exterior mirrors should be pressed to the body to avoid damaging them.
Heated mirrors Heated exterior mirrors is carried out independently of the rear window defogger. Heated include turning the button installation of mirrors to position A.
Memory for exterior mirrors Cars with memory for driver's seat also have memory exterior mirrors. Any fixed position door mirrors automatically stored in the memory in memorizing the driver's seat adjustments. First, adjust the position of the driver's seat. Then mounted mirror according to setting of the driving seat.
Automatic installation of the right exterior mirror when reversing When reverse gear is right outside mirror automatically takes a predetermined position, if such a provision was previously found. Because of this parking is provided visibility of the right curb. The mirror returns to its normal position as soon as reverse gear off. Previously established position of the right exterior mirror for reversing can be tailored to your individual requirements changed and stored.
Installing an internal mirror Manual setting protivoslepyaschego position. Basically mirror lever position below the mirror must be directed forward. To ensure protivoslepyaschego effect should be to move the lever back.
Automatic creation protivoslepyaschego effect Installing the mirror manually. Ignition internal mirror darkens when falling behind the luminous flux (eg headlights); darkening depends on the intensity of the luminous flux from behind. When the reverse gear or move the lever of an automatic transmission in position ?�R?� mirror switch to its original position (without protivoslepyaschego effect).
Sun visors Sun visors can be pulled out from the side holders and turned to the door. Cosmetic mirror is provided with a lid. When lifting the lamp cover is included in the ceiling. Through a small sun visor under the front canopy You can, throwing down the visor, close the slit on the inner mirror.
| 
