 printable version
Screen wipers and washer
| Fig. 1.33. Podrulevoj mode switch and windshield wiper
|
ATTENTION Screen wipers and washer work only with the ignition. When the frost before the first trip for the inclusion of screen wipers should be checked, whether brushes. |
Windshield wipers are turned off Steering column switch in a fixed position 0.
Intermittent motion brushes Steering column switch 1 in a fixed position. A switch can be set four different intervals response brushes. The switch to the right - shorter breaks between operation Switch to the left - elongated pauses between operation Additionally, pauses at each position is adjusted depending on the vehicle speed.
The slow movement of the brush Steering column switch 2 in a fixed position.
Rapid movement of the brush Steering column switch 3 in a fixed position.
Manual control of the movement of brushes (inching mode) Steering column switch 4 in a fixed position.
Automatic cleaning and washing of Shift paddles on the steering wheel to bring 5 - wiper and washer work. Steering column switch release - washer stopped working, the wipers operate even for about four seconds. If you have a heated washer jets switch and regulation of the intensity of heat takes place from the moment the ignition is switched depending on the ambient temperature.
Rain sensor On vehicles with rain sensor mode when the intermittent motion brushes pause time is automatically adjusted depending on the strength of the rain flow. With the regulator A wiper arms can be individually adjust the sensitivity of the rain sensor. After turning off the ignition rain sensor should be re-activated. To do this, turn off the intermittent wiper and turn it back on.
Windscreen When the driving or passing beam each time you turn-stekloomy Vatel windshield and headlamp lenses are washed surface. At regular intervals, eg when refueling, should clean the surface of lenses range from stubborn dirt (eg insects adhering to the glass).
Wiper
ATTENTION Impeccable condition of wiper blades is an indispensable condition for ensuring good visibility. To avoid muddy lanes when driving on glass brushes must be cleaned regularly wiper blades glass cleaner-At strong pollution of brushes, such as the remains of insects, should be cleaned with a sponge brush LIS or a clean cloth. For safety reasons, it should be one to two times a year to replace the wiper blades. If brushes insufficiently well clear windshield, then the following reasons for this: - The passage of the vehicle automatic washing the windshield hit wax particles. These particles may be removed using appropriate detergent. Adding washer fluid glass glass cleaner with voskorastvoryayuschimi properties, you can remove wax particles. Tools with fat-dissolving properties are not suitable for this purpose. - Damage of brushes can also be caused by poor cleaning windows. Brushes should be replaced; - The angle of installation of leads of screen wipers does not correspond necessary. |
Brush Removal Pull the wiper arm away from the glass and rotate the brush in position at right angles to a leash. Push down on the spring in the direction of arrow A. Unlock the brush by clicking on it in the direction of the arrow B, and then remove it with a leash in the opposite direction.
Attaching the brush Retaining spring must audibly engage in the wiper arms. When installing brushes should pay attention to: - Spoiler brush driver's side is at the bottom; - The right brush is facing the arch down.
| 
