REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Touareg
		Operation and maintenance of car
		Engine
			Preliminary checks on the car
			The mechanical part (petrol engines 3,2L)
			The mechanical part (petrol engines 4,2L)
			The mechanical part (diesel engines 5,0L)
			Removing and installing subframe
			Pressurization system (diesel engines)
			Cooling system (petrol engines)
			The cooling system (diesel engines)
			Lubrication (petrol engines)
			Lubrication system (diesel engines)
			Injection System (petrol engines)
			Fuel injection system (diesel engines)
			Exhaust
				Align the exhaust system
				Removing and installing exhaust manifold and front pipe with the primary catalysts
				A secondary air supply system
				Check the combination valve
			FUEL (beninovye engines)
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Exhaust

Align the exhaust system

Removing and installing exhaust manifold and front pipe with the primary catalysts

A secondary air supply system

Check the combination valve

Fig. 2.297. Silencer with mountings: 1 - double clamp 40 Nm; 2 - cavity; 3 - bolt 25 Nm; 4 - suspending; 5 - incision; 6 -glushitel; 7 - suspending; 8 - the double yoke; 9 - suspending; 10 - double clamp

NOTE

After the installation work on the exhaust system, check that the distance between the elements of the exhaust system and the body was sufficient. If necessary, remove the flange on the catalyst and re-align silencers and exhaust pipes.

NOTE

Before removing the receiver tubes with the catalyst necessary to disconnect the battery.

When installing the receiver tubes, check the density of the catalyst after the flange connection. Leakage compound at this point causes the exhaust gas section. Because of this, outside air comes to the lambda probe after catalytic converter and lambda control is broken.

Self-locking nuts must be replaced.

Mounting position of the repair of double clamp in the direction of motion

Fig. 2.298. Mounting position of the repair of double clamp in the direction of motion

1 - The end of the screw should not extend beyond the lower edge of the double collar.

2 - angle 10 ?� + 5 ?�.

« previos page
Replacing the O-rings injectors

next page »
Align the exhaust system