 printable version
Adjusting the headlights
NOTE The figure shows the left headlight. If the test headlamp found after installation uneven gaps between the headlight and the body, it is necessary to adjust its position. |
Turn the ignition and all electrical consumers and remove ignition key. Remove the cover of the front bumper
| Fig. 7.92. Fixing bolts of the guide profile bumper cover
|
Remove the fixing bolts guide profile bumper cover 1 (Fig. 7.92). Remove guide profile bumper cover 1.
Loosen the two front mounting bolts enough to mount the headlamp to move freely in the setting sleeve (Fig. 7.93).
Adjust the gap by loosening or tightening the adjusting nut (Fig. 7.94). Tighten bolts the front headlights to the specified torque Again, check the position of the headlights and, if necessary, adjust the gaps. Install the guide profile the top panel of the bumper. Replace the cover of the front bumper Check the operation of lights, including all of its functions.
NOTE After installing lights or fit to the body is always necessary to carry out its adjustment. Check the setting of the headlights, if necessary - adjust |
| 
