Removal and installation of the brake fluid reservoir

Work should be done in this order:

- Clean the engine compartment area around the main cylinder;

- Put the wiper rags around the main cylinder;

- Drain the brake fluid from the reservoir;

- Remove the cover of the connector.

For vehicles with manual transmission, disconnect the hose that feeds the clutch master cylinder, muffle its aperture;

- Disconnect the brake fluid level in the reservoir (Fig. 6.15);

- Remove the locking pin by means of a 3 mm mandrel;

- The removal of brake fluid from the master cylinder;

- Remove the O-rings from the master cylinder

- Thoroughly clean the reservoir and master cylinder.

- Put the new O-rings in the master cylinder:

- Establish a tank, with increasing press-fitted into place (taking into account the position sensor connector);

- Put the locking pin;

- Connect the brake fluid level (for vehicles with manual transmission);

- Connect the hose that feeds the clutch master cylinder;

- Slowly fill the brake fluid reservoir, a few times slowly depress the brake and clutch pedals.