Filling and bleeding hydraulic clutch system

To fill the system:

- Remove from the drain fitting cap;

- Open the drain fitting;

- Fill the tank with brake fluid (DOT4 +);

- Close the choke as soon as the liquid begins to flow.

To bleed the system:

- Connect the hose to the drain fitting and the other end lower in the capacity partially filled with brake fluid (Fig. 5.7);

- Open the drain fitting;

- Squeeze and slowly release the clutch pedal. Repeat this until the liquid comes out air;

- Close the drain fitting; torque 10 Nm;

- Remove the hose and put the cap.

In the process of pumping watch the level of brake fluid in the master cylinder reservoir, it should not fall below the ?�min?�.