general description

Your car can be optionally equipped with Dynamic Stability Control (DSA). This - the system that prevents wheel spin. It turns on automatically when the engine is started automatically and is valid at all speeds, if one or both drive wheels start to skid or slide while cornering. ABS sensors indicate the engine management system, the wheels rotate at different speeds. Then the engine control system starts to reduce the engine power by reducing the supply of fuel (using specially programmed 16 degrees) until it stops spinning of the wheels. This improves the stability of the vehicle when pulling away and cornering, as well as improves the acceleration on slippery surfaces and slopes.

Optionally DSA system can be turned off by pressing a special switch (fig. 2.16) and holding it pressed for more than half a second. If you turn off the system on the instrument panel will light up the corresponding indicator light.

If the vehicle has a special spare tire (wheel- "dokatka"), it is recommended to turn off the system, because tire it can be different diameters.

In this case, the system must be reprogrammed as follows:

- The system should be included;

- Speed up the movement of up to 70 km / h and reduce the speed to 30 km / h, the engine braking;

- And then repeat this operation again (engine braking instead of the brake pedal).

This operation must be repeated again after installation on a normal car tire.

To enable the system to be re-press the button shown in Fig. 2.16.

When restarting the machine, the system is automatically activated.

When the ignition warning lamp on the instrument panel should come on for a short time, until the system performs self (2 seconds after starting the engine). If the light stays on, this indicates a fault detected in the system.