 printable version
Front Crankshaft Seal
| Fig. 3.1.46. The front and back cover of the engine: 1 - sealing lip; 2 - Woodruff; 3 - bolt 25 Nm; 4 - the front cover; 5 - a lining; 6 - cylinder block; 7 - Flywheel bolts, 60 Nm, and tighten on a corner 180 ?�; 8 - two-mass flywheel; 9 - intermediate plate; 10 - bolt 10 Nm; 11 - Back Cover with a cuff; 12 - a cuff; 13 - an intermediate shaft; 14 - a sealing ring; 15 - flange seal ring of the intermediate shaft
|
Replacing the front seal 1 (Fig. 3.1.46) of the crankshaft is carried out with the engine mounted in the vehicle. Install the front transverse panel in service position (see. "Body"). Remove the timing belt. Remove the bracket bolts compensator reactive moment. Remove the bolt and remove the toothed belt pulley with the crankshaft. When loosening bolts hold the crankshaft pulley from turning over the device 3415.
| Fig. 3.1.47. Bolt cylinder head (of the guide bushing 3083), screwed into the hole of the crankshaft
|
Replace the bolt with cylindrical head (from the guide bushing 3083) into the hole of the crankshaft (Fig. 3.1.47).
| Fig. 3.1.48. Using a stripper in 2085 to remove the front crankshaft seal
|
Remove the inside of the extractor 2085 two turns (about 3 mm) from the outer portion and rigidly fix both sides of the screw. Install the puller on the crankshaft and strongly pressing, screw it into the sealing sleeve. Loosen the locking screw and turn the inside of the puller, remove the cuff. Remove the collar with a stripper. Clean the installation location of the seal. Apply engine oil to sealing lip and an outer surface of the new seal before installing it in place.
| Fig. 3.1.49. Setting the guide bushing 3083 on the crankshaft
|
According to the guide sleeve, set the seal of 3083.
| Fig. 3.1.50. Using the bolts and the mounting sleeve 3083 for pressing the front crankshaft seal in the groove
|
With the help of bolts and mounting sleeves 3083 press in sealing sleeve into the groove (Fig. 3.1.50). Fit the toothed belt pulley bolt on the crankshaft.
A WARNING On the bearing surface between the pulley and the crankshaft and on the pulley bolt of grease. When you install a new bolt, replace the crankshaft pulley. |
Install the timing belt and adjust its tension. Install poly V-belt and adjust its tension. Install the front cross bar to its normal position.
| 
