 printable version
Withdrawal
Be sure to replace all the pads on the same axle of a vehicle, even if only one shoe is worn. Brake pad wear sensor fitted. If the brake pad thickness becomes less than 3 mm, in the instrument cluster warning lamp. If the old brake pads will be established again before removal they are necessary for marking. Loosen the bolts of the front wheel, then lift the front of the car and fix on supports. Unscrew and remove the wheel.
| Fig. 15.9. Location bolts outer brake pad and brake disc
|
Disconnect an electric socket of the gauge of deterioration brake pad and remove the wire from the bracket support. For this blade screwdriver squeeze the rubber plug with a wire from the bracket and turn it 90 ?� to the first one, then the other side.
| Fig. 15.10. Use pliers to remove the spring
|
Squeeze the pliers and remove the top and bottom of the spring and move them to the side (Fig. 15.10).
| Fig. 15.11. Use a screwdriver to force the pistons in the caliper
|
Using a screwdriver blade inserted between the slide and the outer brake pads, push the pistons in the caliper, with the move to the outside caliper (Fig. 15.11). When indentation piston brake liquid is superseded from the brake cylinder in a broad tank, therefore constantly monitor the level in the reservoir and, if necessary pump out from it over. Remove the outer brake pads from the caliper.
| Fig. 15.12. Use a screwdriver to move the caliper to the car
|
Blade screwdriver inserted between the slide and the inner brake pad, move the front brake caliper to the car (Fig. 15.12). Remove the inner brake pads from the caliper.
| 
