 printable version
Recommendations regarding the selection of positions
Engine start The engine can be started only when the selector lever position control in the positions N or P.
NOTE With manual switching from the higher to the lower gear can be mounted selector lever of an automatic transmission in position 4, 3 and 2. Automatic transmission will switch only when not exceeding the maximum engine speed. |
To translate the selector in one of the positions of motion for the vehicle is stationary and the engine running, you should press on the brake pedal. If you select positions in the vehicle is stationary, do not push the accelerator pedal. If while driving selector accidentally transferred to the position N, before the transfer lever in any forward gear position is necessary to release the accelerator pedal and reduce engine speed to idle.
A WARNING With the engine running when the selector lever is in any position motion, you must hold the vehicle by pressing the brake pedal, as even at idle transfer torque to the wheels is not interrupted completely. The vehicle "creeps". If the vehicle is stationary choose one of the positions of movement, in any case, do not push the accelerator pedal (to increase fuel delivery by hand from the engine compartment), otherwise the car starts moving, even when locked parking brake the car. Before undertaking any action with the engine running, set the selector lever to position P and the parking brake to slow down the car. |
Movement from place Select one of the movement positions (R, D, 3, 2, 1). Wait until the transmission gearbox and the start of the vehicle (in this case there is a faint jerk), only depress the accelerator pedal.
Stop When short-term stop, such as at traffic lights, there is no need to move to a position N. It is enough to hold the vehicle by pressing the brake pedal. The engine should work at idle.
Parking In order to prevent uncontrolled movement of the car after it stops always hinder it handbrake. Additionally, put the lever of an automatic transmission to position P. On the road with a bias brake the car parking brake, and then set the selector lever to position P. Thanks to this course of action locking mechanism will not be too heavily loaded, and then you can easily bring the selector lever out of this position.
|
