printable version
Common methods of starting the engine
Methods of starting the engine with the fuel injection system are the same at any temperature outside air and fluid in the engine cooling system. To start enough to just turn the starter motor without touching the accelerator pedal. The engine management system will install the necessary parameters for starting the fuel supply and ignition timing. | | 1. Open the hood by pulling the lever drive of his castle. | 2. Measure the oil level dipstick oil level. It should be between the marks ?�MAX?� and ?�MIN?�. |
| | 3. Check the brake ... | 4. ... and coolant. |
5. Inspect the engine and engine compartment. Pay attention to drips gasoline, oil, brake fluid and coolant. Ensure the continuity of the wiring. Check the fit of high-voltage wires in the sockets of the ignition coil, the candles. 6. Without closing the hood (in case of rain or snow cover it), get behind the wheel. Switch on the ignition by turning the key in the ignition switch to ?�ON?�. This turns elektrobenzonasos. Start up the engine by turning the key in the ignition switch to ?�START?�.
HELPFUL HINTS The hood is better to close once the engine starts. Prior to this, it is desirable to inspect the engine once again, to make sure there are no leaks of fuel, oil, coolant and extraneous sounds in his work. If for any reason during a failed attempt to start will be "flooded" the spark plug, use the mode purge cylinders. To do this, press the accelerator pedal all the way and turn the starter. In this mode, the fuel supply from the cylinders and no fresh air flow removes excess gasoline - spark plugs are dried. After purging the retry start in the usual way. |
If the engine fails to start, there are three main reasons: - It does not work the system start-up; - It does not work the ignition system; - Is not working power system.
NOTE In addition to these main reasons, the engine can not be started when the canister purge valve malfunction or as a result of air leaks through the hose connections of the fuel vapor recovery system. |
|