add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Design Features
Mounting blocks
Accumulator battery
Generator
Starter
The switch (lock) of ignition
The engine management system
Lighting, light and sound alarm
Replacing windscreen wiper motor-reducer
Removal and installation of a washer of glass of a wind window
Removal and installation of the electric motor of the basic fan cooling radiator
Removal and installation of the electric motor of the additional fan cooling radiator
Heated tailgate window glass
Removing and installing cigarette lighter holder
Device combination
Switches dashboard
Replacing the control unit power windows
Car audio system
Replacement sensors and switches
Replacing the sensor signal lamp oil pressure
Checking and replacing the sensor coolant temperature gauge
Checking and replacing the fuel gauge sender
Checking and replacing the reverse gear switch
Replacing the brake light switch
Replacement of the switch signal lamp Handbrake
Replacing the switch room lamp
Body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Checking and replacing the reverse gear switch



Backup light switch mounted on top of the gearbox housing.
You will need a key "19".
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Press the latch and disconnect the connector from the sensor harness.
3. Remove the sensor ...
4. ... and remove it from the vehicle.
5. Remove the seal washer switch.

NOTE
Strong compression washer replace a new one.

6. To test the switch, connect to its conclusions tester ohmmeter mode. Resistance should tend to infinity.
7. Push the plunger switch - resistance should drop to zero. Otherwise, the switch is faulty and should be replaced.
8. Set the items in reverse order.




« previos page
Checking and replacing the fuel gauge sender
next page »
Replacing the brake light switch

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.