REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
			Technical data
			The ignition system of engine DOHC
			Check the ignition coil
			Check spark plugs
			Control of spark plugs
			Check spark plugs
			Checking high-voltage wires
			Ignition coils
			Installation of high-voltage wires
			Troubleshooting
			Egnition lock
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Check spark plugs

PERFORMANCE ORDER

	1. Disconnect the negative battery terminal. For tip disconnect high-voltage wires from spark plugs.
A warning When disconnecting the high-voltage wires from spark plugs pull the tip of the wire, not the cord, as it may be damaged.
2. Compressed air clean spark that will exclude dirt hit in cylinders of the engine after removing the spark plugs. Remove the spark plug using the spark plug spanner. To avoid damaging the spark candle key place strictly along the axis of the candle.

	3. Check the spark plug for the following defects: 1) damage to the insulator; 2) worn electrodes; 3) a deposit; 4) damage to the gasket; 5) the state of the insulator at the tip of the spark plug.
	4. wire template, check the electrode gap of the spark plug. The adjustment of the gap is carried podgibaniem side electrode. Spark plug electrode gap is important because if too much and too small a size of a spark gap is changed, resulting in reduced engine performance. The gap must always conform to the specifications. The central electrode in no case can not be bent, as this may cause damage to the insulator and a candle exit out of operation. For podgibaniem side electrode spark necessary to use a special tool. Electrode spark plug gap: 1.0-1.1 mm
	5. Replace the spark plug in the cylinder head. Torque: 20-30 N ??? m