REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
			Technical data
			Electrical circuits
			Charging System
			Checking the charging circuit
			Check the voltage drop across the wire that connects the battery to the alternator
			Check of the current generated by the generator
			Check voltage release
			Generator
			Accumulator battery
			Check the specific gravity of the electrolyte
			Charging the battery
			Inspection of battery
			Starting system
			Starter
			Check and replacement of elements of the stator
			Switch the ignition lock
			Check the starter relay
			Check the ignition switch lock
			Radio
			Speakers
			Antenna
			Multifunction switch
			Sound signal
			Circuit breakers
			Device combination
			Windshield Wiper Motor
			Replacement lights and front turn signal
			Adjusting headlights
		Appendix
		Wiring

printable version

Checking the charging circuit

PERFORMANCE ORDER

1. Turn on the ignition.
2. After switching on the ignition with the engine running, the test lamp should illuminate charging.
	3. Disconnect the connector from the resistor pre-excitation of the generator. Connect an ohmmeter to terminals 1 and 3 of the connector from the component. Positive dipstick () ohmmeter connected to the terminal 3 and the negative test lead (-) - to terminal 1.
A warning If an ohmmeter is not connected properly, it will not show the resistance value

Result

PERFORMANCE ORDER

1. If there is a conductivity shows ohmmeter, means the electrical circuit in order. If conductivity is absent, then the electrical connection is faulty.

2. If the conductivity is not only in step 3, check and restore electrical circuit control lamp. If conductivity is absent only in step 2, check the resistor pre-excitation of the generator.

A warning

If the conductivity is not only one of the steps 2 and 3, then the system is working properly, however, for more reliable operation of the system is necessary to inspect the electrical circuit.

« previos page
Charging System

next page »
Check the voltage drop across the wire that connects the battery to the alternator