REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
			Technical data
			Electrical circuits
			Charging System
			Checking the charging circuit
			Check the voltage drop across the wire that connects the battery to the alternator
			Check of the current generated by the generator
			Check voltage release
			Generator
			Accumulator battery
			Check the specific gravity of the electrolyte
			Charging the battery
			Inspection of battery
			Starting system
			Starter
			Check and replacement of elements of the stator
			Switch the ignition lock
			Check the starter relay
			Check the ignition switch lock
			Radio
			Speakers
			Antenna
			Multifunction switch
			Sound signal
			Circuit breakers
			Device combination
			Windshield Wiper Motor
			Replacement lights and front turn signal
			Adjusting headlights
		Appendix
		Wiring

Windshield Wiper Motor

Refitting

PERFORMANCE ORDER

	1. Remove the nuts and remove the wiper arms.
	2. Remove the cover below the windshield.
	3. Remove the wiper motor.
	4. Remove the bolts and remove the wiper mechanism.
5. Install in the reverse order of removal.

Check the frequency of wiper

PERFORMANCE ORDER

1. Unplug the connector from the wiper motor.
2. Additional wires connect the positive terminal of the battery to pin 6 of the connector and the negative terminal - to terminal 3.
3. Make sure that the wiper motor operates at low speed.
4. Additional wires connect the positive terminal of the battery to pin 6 of the connector and the negative terminal - to terminal 2.
	5. Make sure that the wiper motor runs at high speed.

Checking the brushes for automatic stop in the initial state

PERFORMANCE ORDER

1. Turn the engine at low speeds.
2. Disconnect the wires from the track 3, stop the engine in any position other than the original.
3. Connect pins 3 and 5 of the connector.
4. Additional wires connect the positive terminal of the battery to pin 6 of the connector and the negative terminal - to terminal 1.
	5. Check that the wiper motor is switched off in the starting position of the wiper blades.