REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
			Manual Transmission
			Automatic transmission
				Technical data
				The control lamp fault (MIL)
				Diagnostic trouble codes
				Read fault codes
				Check the transmission fluid pressure
				Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
				Check the fluid level in automatic transmission
				Check the operation of the selector lever
				Adjustment of the switch indicate the position of the selector lever
				Adjusting the servo compulsory inclusion downshift
				Adjust the line pressure
				Replacement of an oil sealing ring of a power shaft
				Replacement of a cable drive speedometer
				Removing and installing transmission
				Repair Transmission
				Lever
				Control Cable
				Repair of the selector lever
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Adjustment of the switch indicate the position of the selector lever

PERFORMANCE ORDER

1. Move the selector lever to position N.
	2. Loosen the lock nut lever at the connection cable and lever.
3. Move the lever to position N.
4. Rotate the switch position indication selector lever at a distance of up to 12 mm wide, and align the end of the lever to switch the projection.
5. Tighten the switch torque 10-12 N ??? m.
	A warning By turning the switch body, be careful not to damage the O-ring.
6. Make sure that the selector lever is in position N.
7. Adjust the nuts so that there was no slack in the cable and selector lever moves smoothly.
	8. Make a control trip and check that the transmission is set to the position corresponding to each position of the selector lever.