REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
			Technical data
			Lower arm front suspension
			Replace the lower arm bushing
			Replacement of the plug (G) of the lower arm
			Front stabilizer
			Rear strut
			Replacing the rear trailing arm bushings Rear suspension
			Replacing the rear control arm bushing (A and B) of the rear suspension
			Rear anti-roll bar
			The corners of the front axle
			Adjustment of a convergence of back wheels
			Tyre wear
			Anti-skid chains
			Runout
			Tightening the wheel nuts
			Shift of wheels
			Check withdrawal and course instability of the car
			Caring for aluminum alloy wheels
			Troubleshooting
			Diagnosis tire wear
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Front stabilizer

Withdrawal

PERFORMANCE ORDER

1. Remove the front wheel.
	2. Remove the stabilizer rod.
3. Remove the bracket and stabilizer bushing
	4. Remove the rear engine mounting.
5. Remove the stabilizer bar.

Check

PERFORMANCE ORDER

1. Check the stabilizer bar on the lack of elasticity loss and damage.
2. Check all the bolts.
3. Check the dust cover rod stabilizer for cracks or damage.
	4. Check the torque that must be applied to crank pin of the spherical hinge of draft of the stabilizer. If there are cracks in the protective cover, replace it and add grease in the joint. Several times rocking from side to side of the hinge pin of the spherical rod stabilizer. Torque: 1,7-3,2 N ??? m If the torque exceeds the allowable value, replace the stabilizer rod. If the torque is significantly lower than the allowable value, the ball joint can be reused if it is not jammed and is not excessive backlash.

Setting

PERFORMANCE ORDER

1. Establish the plug on the stabilizer bar.
	2. Align the bracket with respect to the sleeve. Make sure that the bracket is securely covers the sleeve.
	3. Temporarily secure the bracket bushing and install the sleeve on the second side of the stabilizer.
4. Secure the stabilizer rod wrench open-end wrench 14 mm and screw the self-locking nut.

next page »
Rear strut