REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Elantra
		Gasoline engines 1.6, 1.8 and 2.0 liters
		The diesel engine of 2.0 liters
		Greasing system
		Cooling
		Fuel system
		Control systems and emission control
		Ignition system
		The system of preliminary heating of the diesel engine
		Coupling
		Manual transmission
		Automatic Transmission
		Drive shafts, front and rear axles
		Suspension
		Steering
			Technical data
			Check of a free wheeling of a steering wheel
			Checking steering angle of front wheels
			Check torque pin of the spherical rod end
			Check of effort steering
			Checking the steering wheel return to its original position
			Checking the belt drive power steering pump
			Check the fluid level
			Liquid replacement in a hydraulic drive power steering
			Bleeding the hydraulic system of the power steering
			Checking the fluid pressure in the hydraulic system
			The steering column / steering shaft
			Removing and installing steering column lock
			Steering transfer
			The power steering hoses
			Filling fluid Power Steering
			Power steering pump
			Troubleshooting steering
		Brakes
		Body
		The air conditioning system
		Electrical equipment
		Electrical diagrams

Bleeding the hydraulic system of the power steering

PERFORMANCE ORDER

Pour the liquid in a tank recommended the power steering to the mark "MAX".
Lift up the front wheels.
Disconnect the high-voltage wire from the ignition coil. Periodically turn the starter for 15-20 seconds and at the same time 5-6 times turn a steering wheel from lock to lock.

In the process of pumping the liquid is constantly top up to the level in the reservoir does not fall below the filter settings.
If pumping perform when the engine crankshaft is not rotating, the air is again dissolved in the liquid.

Connect the high-voltage wire to the ignition coil, start up the engine and let it run at idle speed.
Turn the steering wheel from lock to lock several times. Make sure that the liquid does not foam and its level has not gone down.

To avoid damage, do not hold the steering wheel turned fully for longer than 10 seconds.

Make sure that the liquid does not have a milky color and its level is between labels ?�MIN?� and ?�MAX?� on the reservoir.
Check that there is a slight change in the fluid level when the steering wheel to the left and right sides.

If the liquid level changes of more than 5 mm repeat the pumping of hydraulic power steering.
If the fluid level rises suddenly after the engine stops, it means that the system still has the air.
If the hydraulic drive the power steering has the air when the pump will hear background noise. Air in the system will reduce the life of the pump and other parts.