add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)
general info. full specifications. diagnostics. hints. tips. tricks
 Hyundai Elantra
Home
 
Hyundai
Elantra
Gasoline engines 1.6, 1.8 and 2.0 liters
The diesel engine of 2.0 liters
Greasing system
Cooling
Fuel system
Control systems and emission control
Ignition system
The system of preliminary heating of the diesel engine
Coupling
Manual transmission
Automatic Transmission
Drive shafts, front and rear axles
Technical data
Drive shaft
Drive shaft with SHRUS ball-type and type Birfield
Drive shaft with SHRUS Birfield (BJ) and tripoidnogo type (TJ)
A rotary fist and a nave of a forward wheel
Rear axle / rear wheel hub
Troubleshooting
Suspension
Steering
Brakes
Body
The air conditioning system
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Rear axle / rear wheel hub



Withdrawal

PERFORMANCE ORDER

  1. Loosen the nuts of the rear wheel.
  2. Lift the car and fix on support.
  3. Unscrew the nuts and remove the rear wheel.
  4. Hammer and chisel to remove the hub cap.
  5. Peel back the collar, loosen the nut of the rear wheel hub and remove tab washer.
  6. Remove the gauge ABS.

When removing the ABS sensor, be careful not to hit the tip of the probe on the teeth of the rotor, or other elements.
  1. Remove the caliper and secure it with wire rack to the rear suspension.
  1. Remove the brake disc and the hub of the rear wheel.
  1. Remove the screw and remove the brake disc from the hub of the rear wheel.
  • Needlessly do not remove the bearing from the hub of the rear wheel.
  • Be careful not to damage or scratch the teeth of the rotor. Eliminate the fall of the rotor. If the teeth of the rotor will be damaged by this operation violates the anti-lock braking system.

Check

PERFORMANCE ORDER

  1. Check O-ring for wear and damage.
  2. Check rear wheel bearing for wear and damage.
  3. Check the rotor speed sensor on the rear wheel no chipping of teeth.
  4. Check the support hub for cracks.

Setting

PERFORMANCE ORDER

  1. Screw a new nut with a fillet and hammer in a nut fillet into a nave groove.
When installing, use a new nut with a fillet.
  1. Place the sensor ABS. Insert the probe into the gap between the sensor and the teeth of the rotor and tighten the sensor into a position that provides the required clearance. The gap sensor ABS: 0,2-1,3 mm.
  1. Install the hub cap.




« previos page
A rotary fist and a nave of a forward wheel		 next page »
Troubleshooting

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.