|
|
 printable version
Vacuum brake booster
Withdrawal | - Disconnect the brake pipes from the master cylinder.
 | - Remove the brake master cylinder. Torque: 8.12 N ??? m.
|
- Disconnect the vacuum hose from the vacuum brake booster.
- In the car, remove the spring pin and remove the pin with a head and a hole for the pin.
- Remove the four nuts of the vacuum brake booster.
 | - Remove the vacuum brake booster.
|
|
|
Setting | - When installing the brake servo, remove the two sides of the amplifier transport packaging.
- Install a vacuum brake booster with a new seal on the bulkhead and secure with four nuts. Torque: 13-16 N ??? m.
- Apply a layer of grease on the mounting hole in the brake pedal.
 | - Connect traction brake pedal and set the pin with a head and an aperture under the pin and secure it with a new spring cotter pin.
|
- Install the brake master cylinder to the brake servo and secure the nuts. Connect the brake pipes and tighten the nuts connecting tubes.
- From the engine compartment, connect the vacuum hose to the brake servo.
- Fill popolnitelny tank of brake system with brake fluid. Remove air from the hydraulic circuit brake system.
- Check the brake fluid leaks.
 | - Check and, if necessary, adjust the height of installation of a pedal and brake pedal free wheeling.
|
- After installation, lubricate the contact point of the brake pedal and pull.
|
|
|
|
