 printable version
Dashboard
A WARNING Operation removal and installation of the instrument panel must be performed carefully. When removing, ensure complete separation of electrical connectors. When replacing, ensure the correct routing and securing wiring harnesses. |
| Fig. 7.37. Dashboard: 1 - central bracket; 2 - facing the instrument cluster; 3 - the center trim panel; 4 - the instrument panel assembly; 5 - ducts; 6 - lower frame; 7 - bottom right trim panel; 8 - hinge cover glove box; 9 - the glovebox; 10 - a cover of the glove compartment; 11 - the side panel trim; 12 - ashtray; 13 - rear ashtray; 14 - covers the steering column; 15 - the center console; 16 - Sidebar switches; 17 - lower left trim panel; 18 - an arm of the lower left panel finishes; 19 - ventilation grille
|
Elements of the instrument panel are shown in Fig. 7.37.
Refitting Switch off the ignition and disconnect the wire from the negative battery terminal. Disconnect the connectors on the front seat, then remove the four screws and remove the front seat.
A WARNING When removing do not damage seat upholstery. |
Flathead screwdriver, remove the upper trim from the windscreen pillars. On the reverse side of the steering wheel with an Allen wrench, remove the screws and remove the driver's airbag (DAB). Remove the pin driver's airbag and horn button. Loosen the nut of the steering wheel. After applying the marks on the steering shaft and steering wheel remove a steering wheel special tool (09561-11001).
A WARNING Do not shoot down the steering wheel with a hammer - so you can damage the injury-preventing mechanism of the steering column. |
Remove the screws and remove the upper and lower casings of a steering column. Disconnect connectors and remove the multi-selector.
| Fig. 7.38. Tighten the screws on the lower instrument panel trim
|
Remove the two screws and remove the lower trim panel of devices (Fig. 7.38).
| Fig. 7.39. Location of bolts and nuts bottom bracket facing the instrument panel
|
Remove the two screws and two nuts, remove the bottom bracket facing the instrument panel (Fig. 7.39).
| Fig. 7.40. Location screws cladding dash
|
Remove the screws and remove the lining of the instrument cluster (Fig. 7.40).
| Fig. 7.41. Location screws dash
|
Remove the screws and remove the side panel trim. Use a screwdriver to pry off the decorative top cover at the back of the center console.
| Fig. 7.34. Location screws decorative top cover at the back of the center console
|
Remove the two screws and remove the decorative top cover on the rear of the center console (see. Fig. 7.34).
| Fig. 7.35. Arrangement of bolts and screws holding the center console
|
Remove the two screws and the two screws holding the center console (see. Fig. 7.35).
| Fig. 7.36. Location lateral screws center console
|
Remove the four side screws and remove the center console (see. Fig. 7.36). Flathead screwdriver detach from the dashboard central panel and disconnect it from the connectors. Remove the screws, remove the radio and air conditioning control panel. Remove the screws and remove the glove box.
| Fig. 7.42. Location screws lower center paneling
|
Remove the six screws and remove the bottom panel of the central finishing (Fig. 7.42).
| Fig. 7.43. Location screws dashboard
|
Disconnect the instrument panel connectors. Remove the duct from the instrument panel. Remove the screws and remove the dashboard side air vents. Remove the screws and remove from the instrument panel passenger airbag. Installation is performed in reverse order of removal. Securely connect and secure all connectors.
| 
