- Disconnect the negative wire from the battery.
- Remove the center dash trim (Section Removal and installation of facing the dashboard).
- Take two screws behind the central portion upper cladding which serve for fastening the dashboard.
- Having hooked, remove the grate air vents of the windscreen, remove any existing sensors and set the bars to the side.
- Give the four screws inside the sleeve of glass blowing, which are used to fasten the instrument panel.
 | - Give screw sleeves blowing windscreen (arrow).
|
- Open the glove box, give the two screws securing the instrument panel, and then pull the panel up to release it from the clamps on the edges.
- Take the three screws securing the lining of the instrument cluster to the dashboard, remove the trim.
 | - Give fixing screws facing a combination of the instrument panel (arrows).
|
- Install in reverse order.
|
|
