 printable version
Removing and installing interior door trim panel
| - Disconnect the negative wire from the battery.
- Give fixing screws and armrest upholstery.
 | - Phillips screwdriver, unscrew the screws that secure the inside door trim panel.
|
 | - Give upholstery screw located inside the armrest.
|
 | - Give fixing screw, and then pry the cover facing the inside door handle.
|
- On models with manual transmission lowering-raising glasses, remove the crank drive.
- Insert the special tool to release the locks the door trim panel (ask in shops of automobile accessories) or a putty knife between the skin panel and the door and release the latches. Moving around the perimeter of the trim panel, finally release it.
- After releasing all the locks Disconnect electrical harness connectors under the trim panel and remove the latter from the door.
 | - Pull the door trim panel and disunite electric sockets passing under it to the wiring harness.
|
- To provide access to the inside surface of the door, carefully separate from her plastic water filter.
 | - Carefully separate the door from the inside surface of a plastic water filter - try not to break or deform it.
|
- Before installing the interior door trim panel, make sure that it inserted all the clips that are in the process of removal may remain in the door itself.
- Connect the electrical wiring connectors and attach the trim panel to the door in its installation position. Alternately all snap locks.
- Replace the armrest and lever lowering-raising drive glass.
|
|
|
