|
|
 printable version
A rotary fist and a nave of a forward wheel
Withdrawal | 1. Raise the vehicle and remove the front wheel.
2. Remove the wheel speed sensor from the hinge.
3. Remove the brake hose from the steering knuckle.  | 4. Remove the caliper and a soft wire fix it on the front rack. |
 | 5. Remove the cotter pin and loosen the nut on the drive shaft. |
 | 6. Remove the 2 screws and remove the lower arm ball joint from the knuckle. |
 | 7. kapron hammer beat out a power shaft from the front wheel hub. If the drive shaft is firmly seated in the hub of the front wheel, spray impregnation spray solvent on the area of the splines and then re-screw the nut with flange so that it is flush with the end of the shaft. Striking on a nut a brass hammer, beat out a power shaft from a nave. |
 | 8. Remove the cotter pin and loosen the nut trunnion ball joint tie rod to the steering knuckle. 09568-34000 stripper squeeze out a pin of the ball joint from the knuckle.  | Secure the cord puller for the next element of the car. Loosen the nuts, but do not remove them. |
|
9. Remove the mounting nut of the upper arm.  | 10. Using the special tool, remove the upper arm from the steering knuckle. |
11. Remove the front axle with the steering knuckle.
12. Install in the reverse order of removal. |
|
Dismantling | 1. Remove the brake disc.  | 2. Remove the snap ring. |
 | 3. Using the special tool, remove the hub from the knuckle. |
 | 4. Using the special tool, remove the inner ring of the bearing from the wheel hub. |
 | 5. Using the special tool, remove the outer ring of the wheel bearing from the steering knuckle. |
|
|
Check | 1. Check the hub for cracks and wear.
2. Check the hinge for cracks.
3. Check the inner surface of the knuckle for cracks or damage. |
|
Assembly | 1. Apply a thin coat of grease into the hole on the steering knuckle and the outer ring of the bearing.  | 2. press with corresponding diameter mandrel press in new wheel bearing in the knuckle. |
| - Do not force the press to the inner ring of the bearing.
- When installing, always use a new bearing.
- Install the snap ring in the groove of the knuckle.
- A press with a mandrel of appropriate diameter to press-fit the hub knuckle.
|
| Do not force the press to the outer ring of the bearing. |
 | 5. The special tool tighten the hub to knuckle by tightening the bolt fixtures torque of 200 N ??? m. |
6. Several times turn the hub to the bearing elements established in its place.  | 7. Measure the torque which must be applied for the rotation of the bearing. Torque: 1.8 N ??? m |
 | 8. The test for determining whether the hub in the axial gap accurately defined limits offline. Axial bearing clearance: 0,08 mm |
9. Remove the special tool.
|
|
|
|
