REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Magentis / Optima (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Magentis
		Engines
		Lubrication System
		Cooling system
		The control and toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Power shafts, axles
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Adjust the parking brake stroke
			Brake pedal
			The main brake cylinder
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Replacing the front brake pads
			Caliper front brake
			Rear drum brakes
			Replacing the working brake cylinder
			Rear disc brakes
			Saddle
			Hydraulic block HECU (the hydraulic and electronic control unit)
			Wheel speed sensor
			Parking brake
			Troubleshooting
		Body
		The air conditioning system
		Electrical equipment
		Electrical diagrams

printable version

Wheel speed sensor

Withdrawal

The front wheel speed sensor

PERFORMANCE ORDER

1. Remove the bolt of the front wheel speed sensor.

2. Disconnect and remove the front the wheel speed sensor.

Rear wheel speed sensor

PERFORMANCE ORDER

1. Remove the rear seat cushion.
2. Remove the C-pillar trim.

3. Remove the rear wheel.

4. Disconnect and remove the rear wheel speed sensor.

Check

PERFORMANCE ORDER

1. Between the terminals of the connector, measure the resistance of the wheel speed sensor.

Resistance:

Front sensor: 1275-1495 Ohm
The back gauge: 1275-1495 Ohm

2. Connect the voltmeter to the terminals of the sensor connector, measure the voltage generated by the sensor when the wheel rotates.
Set the voltmeter to measure AC voltage.

« previos page
Hydraulic block HECU (the hydraulic and electronic control unit)

next page »
Parking brake