 printable version
Wipers and windshield washer
Withdrawal |  | 1. Remove the cover and turn the wiper arm nuts. Remove the wiper arms.  | When removing wiper arms not to scratch the hood. |
|
 | 2. Open the hood. |
 | 3. Remove the nut, loosen the clamps and remove the vent chamber at the base of the windshield. Disconnect the connector and remove the engine and pull the wiper. |
|
|
Check the frequency of wiper | 1. Unplug the connector from the wiper motor.
2. Additional wires connect the positive battery terminal to terminal 6 of the connector and the negative terminal - to terminal 3.
3. Make sure that the wiper motor operates at low speed.
4. Additional wires connect the positive battery terminal to terminal 6 of the connector and the negative terminal - to terminal 2.  | 5. Make sure that the wiper motor runs at high speed. |
|
|
Checking the brushes for automatic stop in the initial state | 1. Turn the engine at low speeds.
2. Disconnect the 3 connectors, stop the engine in any position other than the original.
3. Connect terminals 3 and 5 of the connector.
4. Additional wires connect the positive battery terminal to terminal 6 of the connector and the negative terminal - to terminal 1.  | 5. Check that the wiper motor is switched off in the starting position of the wiper blades. |
|
|
Testing the engine washer | 1. With the washer motor connected to the washer tank, fill the washer tank with water.  | 2. Additional wires connect the positive terminal of the battery to terminal 2 and the negative terminal - to terminal 1, the engine must be running and the pump to pump water. |
|
|
|
