 printable version
Adjustment of the switch range gearbox
Disconnect the negative battery terminal.
| Fig. 3.82. Removing the control cable transmission
|
Remove the nut and disconnect a cable transmission control (Fig. 3.82).
| Fig. 3.83. Installing the switch shaft ban start in N
|
Set the switch shaft prohibition to position N, as shown in Figure 3.83.
| Fig. 3.84. Disconnecting switch prohibition launch
|
Disconnect the switch connector prohibition run (Fig. 3.84).
Connect an ohmmeter to terminals B and C switch connector prohibition run (Fig. 3.86). Turn the switch prohibition start, define the position at which there is conduction between the connector terminals. Nominal values ohmmeter reading of 750 ohms. Tighten the switch prohibiting launch. Tightening torque: 8-11 Nm. Make sure that the position corresponds to the position of the selector switch prohibiting launch. Connect the switch prohibiting launch.
| Fig. 3.87. Locking the control cable transmission
|
Install the lock control cable transmission, as shown in Figure 3.87. Tighten the nut on the gearbox control cable and adjust its position. Install the clamp and wire transmission control. Connect the battery negative terminal.
| 
