REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
			Mounted components of a body
				Removing and installing bonnet
				Adjusting the hood
				Removal and installation of the panel front wing
				Removing and installing front bumper
				Removing and installing rear bumper
				Door
				Removing and installing front door
				Removing and installing rear door
				Adjusting the door
				Adjusting tailgate
				Removing and installing the glass front door
				Removal and installation of glass of a back door
				Removal and installation of the block of the front door
				Removal and installation of the block back door
				Windows
			Glazing Body
			Seats
			Air conditioning and heating
			Tables

printable version

Removing and installing front bumper

Disconnect the negative battery cable.

Fig. 8.13. Disconnecting the castle bumper

Pull the ends of the front bumper (Niche wheels) outward to disengage the lock bumper (Fig. 8.13).

Fig. 8.14. Removing front bumper: 1 - screw A; 2 - connector A; 3 - screw B; 4 - a bolt; 5 - connector B; 6 - the front bumper

Remove in the order shown in Figure 8.14.

Remove the front bumper.

ATTENTION

If the front bumper is released on one side only with the fall of the bumper, it can be damaged. When releasing the lock of the front bumper, attach the bumper so that it does not fall.

Spread the ends of the front bumper (wheel well).

Attach the front bumper to the body.

Push the connecting portion of the front bumper towards the bodywork in order to insert them into the locks of the bumper.

Install in the reverse order of removal.

« previos page
Removal and installation of the panel front wing

next page »
Removing and installing rear bumper