REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
			Mounted components of a body
				Removing and installing bonnet
				Adjusting the hood
				Removal and installation of the panel front wing
				Removing and installing front bumper
				Removing and installing rear bumper
				Door
				Removing and installing front door
				Removing and installing rear door
				Adjusting the door
				Adjusting tailgate
				Removing and installing the glass front door
				Removal and installation of glass of a back door
				Removal and installation of the block of the front door
				Removal and installation of the block back door
				Windows
			Glazing Body
			Seats
			Air conditioning and heating
			Tables

printable version

Removing and installing rear bumper

Disconnect the negative battery cable.

Remove the luggage compartment cover.

Remove attachment and slightly bend the trunk side trim. (right)

Remove attachment and slightly bend the trunk side trim. (left) (4SD)

Remove the service hole cover. (left) (5HB)

Remove the rear combination lamp.

Disconnect the connector of a lantern lighting the plate.

Fig. 8.15. Removing the rear bumper: 1 - screw A; 2 - the screw B; 3 - screw C; 4 - connector A; 5 - a bolt A; 6 - connector B; 7 - rear bumper; 8 - a reflector; 9 - a bolt B; 10 - power rear bumper

Remove in the order shown in Figure 8.15.

Remove the rear bumper.

Fold the edges of the rear bumper (wheel well) out.

Attach the rear bumper to the body.

Push the connection of the rear bumper toward the body to insert them into the locks of the bumper.

Install in the reverse order of removal.

« previos page
Removing and installing front bumper

next page »
Door