add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
Transmission
Clutch
Manual Transmission
Overview
Checking and changing the oil in a mechanical transmission
Removing and installing speedometer car (without DLD)
Replacing the oil seal (differential)
Removing and installing gearshift
Carter clutch housing demolition elements of the main transfer
Testing and assembly of components of the differential and final drive housing
Installing bearing toothed gears
Assembling the roll pin
Adjust the preload in the bearing
Setting the differential in the clutch
Installing crankcase main gear
Eliminating gaps primary, secondary shaft and the shaft of the differential housing of the main transfer
Measurement of the load of the primary, secondary shaft and the shaft of the differential housing of the main transfer
Automatic transmission
Drive Train
Tables
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Testing and assembly of components of the differential and final drive housing








Assembling the components of the differential
Fig. 3.50. Assembling the components of the differential 1 - ring gear and housing; 2 - the bearing (on the side of the ring gear); 3 - the speedometer drive gear; 4 - the bearing (the side opposite to the ring gear); 5 - thrust washer; 6 - side gear; 7 - thrust washer; 8 - Sat; 9 - axis of satellites; 10 - cylindrical pin



NOTE
The assembly is carried out in the manner indicated in Figure 3.50. Installation of the individual components of the differential, as well as the screening procedures are presented below in this section.




« previos page
Check of elements of the input shaft
next page »
Installing bearing toothed gears

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.