printable version

Replacement of lamps of internal lighting

The main cabin lighting

Replacing the lamp main salon lamp

1 - Ceiling 2 - Samples 3 - Planters tabs 4 - The guide grooves	N70 - panel overhead console N70e1 - Lamp main salon lamp

PERFORMANCE ORDER

Having hooked a screw driver through the sample (2) and release the landing flaps (3) of the guide grooves (4), remove the bowl (1) of the main cabin lights. In a clean, dry cloth grab the lamp (N70e1) and release it from the contact terminals. Installation is in the reverse order - track correctness of hitting landing flaps (3) the ceiling (1) in the guide grooves (4) console panel (N70).

Front spotlights (reading lights)

Replacement front lamps designed fixtures

1 - Cartridge	N70 - panel overhead console

PERFORMANCE ORDER

On models corresponding complete set (code ET2) activate the service mode of the emergency call TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last. 7 - Auxiliary battery 8 - terminal positive wire module 9 - negative terminal wire module W10 - Ground Battery Remove the roof console (N70) (see. Section Removal and installation of the roof console panel). Turning in the direction of the arrows, remove the cartridge (1) of the respective lamp. In a clean, dry cloth grab the lamp and release it from the contact terminals. Installation is in the reverse order - with the appropriate configuration (code ET2) deactivate service mode of TELE AID see. Section Activate / deactivate the service mode of the emergency call TELE AID). Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor) and perform basic programming.

The rear cabin lights (Versatile model)

Replacing Lama rear cabin lamp

2 - Connector 3 - Lamp E15 / 8 - Left rear cabin lamp	E15 / 9 - The right rear cabin lamp

PERFORMANCE ORDER

Release clamps, release the rear lamp assembly (E15 / E15 or 8/9) of the roof panel trim. Disconnect the connector (2) wiring. In a clean, dry cloth grab the lamp and release it from the contact terminals. Installation is in the reverse order.

Rear spotlights (Versatile model)

Replacing the rear lamps designed lamps (E11 / E11 and 1/2)

PERFORMANCE ORDER

Hooking a long wedge, gently release the lamp (E11 / E11 or 1/2) of the roof panel trim, taking care not to damage the latter. In a clean, dry cloth grab the lamp and release it from the contact terminals. Installation is in the reverse order.

Lantern lighting the glove box

Replacing the lamp (1) highlighting the glove box

PERFORMANCE ORDER

Open the lid of the glove compartment, and gently release the torch from clamps. In a clean, dry cloth grab the lamp and release it from the contact terminals. Installation is in the reverse order.