|
|
 printable version
Removal, installation and adjustment of the side doors
| - Remove the door trim (see. Section Removing and installing door trim panels).
- Remove the glass door (see. Section Removal and installation of glass windows and side doors).
- Disconnect and remove the wiring holder in the door, and then pull out the door wiring harness.
 | - Give fixture stroke limiter door.
|
 | - Give nuts hinge to the door and remove the door.
|
- Installation is in the reverse order. Finally, adjust the position of the door.
 | Below is a description of the adjustment of the side doors of the 5-door model. In the 3-door models adjustment is similar. |
- To adjust the front door, remove the wing (see. Section Removal and installation of a forward wing and lockers), release the hinge bolts to the front of the body and move the rear edge of the door so that it is level with the wing and the rear door (3-door models - to the body), and gaps between the door and the wing as well as between the front and rear doors (3-door model - between the rear part of the door and the body) were 4.7 ?� 1 mm. After adjustment Tighten hinges.
- To adjust the rear door must be removed first-pillar trim panels (see. Section Removal and installation of other decorative panels), and then, working from inside and outside the car, release the bolts and nuts loops back door to the bar. By moving the rear part of the back door, set it so that it is level with the front door and the body, and the gaps between the doors and between the rear of the door and the body were 4.7 ?� 1 mm. After adjustment Tighten hinges.
 | - Loosen the screws that secure the door lock striker and adjust its position so that the lock is engaged with the striker straight. Tighten the screws that secure the striker.
|
|
|
|
|
