 printable version
Replacement lamps lighting
 | Incandescent lamps should be replaced only by the same type. Before replacing the lamp, make sure that the appropriate light unit was turned off. Do not take the incandescent bulb with bare fingers, use a clean towel or cotton gloves. Fingerprints left on the bulb, vaporized and deposited on the reflector, which is especially noticeable on headlamps and fog lamps. Accidentally left fingerprints should be removed with a napkin soaked in alcohol. It is not allowed to wipe the reflector headlamps, coated with a protective varnish, dry hard cloth, and apply for this purpose any cleaners or solvents. Use a damp, soft cloth. |
 | Halogen bulbs are under pressure and can burst. Therefore, their replacement should use protective goggles and gloves. When replacing the xenon lamps there is a risk of injury due to high voltage! Be sure to turn off the headlights and disconnect the wiring from the battery. After replacing briefly switch on and off lamp, to remove the residual stress. As a security measure, wear shoes with rubber soles. |
| - Turn off the ignition and the appropriate lighting unit, disconnect the negative battery cable.
- After installing a new bulb, check her work.
|
|
Block lights The components of the installation of lamps lens unit 
| - To replace the halogen light and dipped beam disconnect its socket, remove the rubber cover and spring clip.
- To replace the parking light bulb holder, turn it clockwise and pull out the lamp.
|
|
Fog lights | - Remove the locker corresponding wheel arches and bumper (see chap. Body).
- Turn the bulb holder anti-clockwise and pull the lamp.
|
|
The front and side direction indicators License plate light and brake light upper level Lamps rear lamp cluster Cabin Light
|
